technical information

At Demonprint as with most printers we are Apple Mac based and therefore our preference for artwork is ‘print ready’ PDF files.

‘Print Ready’ is minimum 300dpi. All fonts should be embedded upon creation of said PDF.

Artwork formats accepted

As well as PDF files we will also accept Quark, Indesign (all images & fonts used must be sent), Freehand, Illustrator (turn all fonts to ‘paths’ or ‘outlines’, particularly if created on a PC), EPS, JPG, TIFF etc.

If in doubt please contact us and we will confirm if your format is acceptable. We do not accept MS Word files.

Artwork Bleeds
Should your artwork bleed off, we require a 3mm bleed all round with crop marks.

Custom Sized Work
Any custom sized work must be supplied with crop marks. Prices for custom sized work are dependent on how many will fit on an SRA3 sheet.

This figure will then be divided into the total number you require, resulting in the number of SRA3 sheets needed for printing.

Brochures and Booklets should be spread in printers pairs or sent as single pages to be imposed. However, Imposition by us may occur you extra cost.

Always check artwork before submitting
Please always check your artwork before submitting it to us to print.

If you require any changes to your artwork we charge £40 per hour should these need to be made. We will of course always notify you should your artwork require change by ourselves before the work is carried out.